Hydraulic Steering Pump
To order, send me an email through the contact page on this site or find me on Facebook
1. Standard pump kit: $600
(Pump, bearing support, regulator)
2. LS 4.8, 5.3, 6.0 Standard bracket: $40
(Truck Spacing)
3. LS 4.8, 5.3, 6.0 High Location Bracket: $45
(Used with Rockwell axles, Truck Spacing)
4. LS 4.8, 5.3, 6.0 AC location bracket: $55
(Uses Stock AC Belt And Stock LS pump Pulley)
(Select car or truck spacing)
5. Stock LS pump pulley: $30
(6 rib serp. 6.625", use with 7.625" crank pulley)
6. 1 Gallon Reservoir: $240
(6x6x7tall)
(Pump, bearing support, regulator)
2. LS 4.8, 5.3, 6.0 Standard bracket: $40
(Truck Spacing)
3. LS 4.8, 5.3, 6.0 High Location Bracket: $45
(Used with Rockwell axles, Truck Spacing)
4. LS 4.8, 5.3, 6.0 AC location bracket: $55
(Uses Stock AC Belt And Stock LS pump Pulley)
(Select car or truck spacing)
5. Stock LS pump pulley: $30
(6 rib serp. 6.625", use with 7.625" crank pulley)
6. 1 Gallon Reservoir: $240
(6x6x7tall)
Toyota Drive Shaft Carrier Bearing: $450
30 Spline Toyota Flanges without holes so you can drill your own to match your drive shafts. 4340 Heat treated shaft. Tapered roller bearings and grease seals.
7.88" flange to flange, 3.5" OD Tube
30 Spline Toyota Flanges without holes so you can drill your own to match your drive shafts. 4340 Heat treated shaft. Tapered roller bearings and grease seals.
7.88" flange to flange, 3.5" OD Tube
Extreme Travel HD Drive Shafts

These drive shafts use 1-3/4" dia. 4140 rolled splined shafting and 1217 internally splined sleeves. The tubing used is 1/4" wall DOM tubing of various ODs depending on yoke sizes. Any amount of travel is possible with this design and the splines are located on the transfer case output side so they are more protected from rock rash.